While doing my distributor awhile ago i noticed this big obstructive muffler looking thingy sticking out of the block under the intake manifold, which turned out to be the air oil seperator before the pcv valve.
It looks like a pain to remove without pulling the intake off but its definately full of crud, and the pcv valve was stuck shut from all the crud in that.
I cleaned out the pcv but i might just replace it for peace of mind. The separator i dont know where to go on this.
Searching around i see some can/cylinder shaped ones with a smaller looking outlet barb on it, i dont see one like the one i have anywhere so im assuming its not available anymore.
What are my options here?
Can i just replace it with one of these can shaped ones or will i need a new hose to the pcv valve also?
If so is the pcv valve the same one or is it different?
Is cleaning it or replacing the media inside it a feasible alternative?
Connect With Us