Close



  • Basin Motorsports

    There is no available content written by Basin Motorsports
  • New Classified Posts

    STREETFIGHTER50

    79-86 Nicely Modded Hatch or Notch

    Im in Rocklin, CA, but Id travel for a car that I like. 86 would be my top choice, but depending on the mods and how clean 79-86 is fine.

    STREETFIGHTER50 Yesterday, 05:34 PM Go to last post
    FoxChassis

    79-86 Nicely Modded Hatch or Notch

    Full location (city and state) required.

    It would also help if you indicated which year(s) you wanted, which is limited to 79-86.

    FoxChassis Yesterday, 03:40 PM Go to last post
    STREETFIGHTER50

    79-86 Nicely Modded Hatch or Notch

    Itchin for another clean Fox. Would like a tastefully modified street car that can handle some spirited driving up in the foothills once in a while. I

    STREETFIGHTER50 Yesterday, 01:25 PM Go to last post
    airplanedriver

    Entex 1/20 scale mustang cobra model

    Kinda rare early 80s Entex mustang cobra 1/20 scale model. Kit is complete.only issue is box top is discolored and has random tape marks. Check out pics,

    airplanedriver Yesterday, 12:53 AM Go to last post
    bwguardian

    Amp pull switch

    That's what I recall from my ole 82 GT from back in the day. My girlfriend at the time had an 83 which did not have it, but hers was a late 83 with the

    bwguardian 01-17-2022, 01:42 PM Go to last post
    noac

    Ford Motorsport 17 air cleaner lid like new

    Sold..

    noac 01-16-2022, 06:03 PM Go to last post
  • Recent Forum Posts

    Foxy 83.5

    '83 4bbl leak at compression fitting

    I had same leak years ago. I strongly recommend Gasoila sealant. Worked perfectly and hasn’t leaked a drop since. Available on Amazon and at home

    Foxy 83.5 Yesterday, 11:48 PM Go to last post
    cougman67

    Oil pump driveshaft question

    Hello all, I just had my SVO engine overhauled. I installed the distributor in yesterday and found the driveshaft wasnt installed. I ordered a new driveshaft

    cougman67 Yesterday, 10:48 PM Go to last post
    stangPlus2Birds

    Weld question

    Take the wheel off the car. Deflate the tire.
    Put the tire on a flat surface.
    Put a straight-edge (a straight 2x4 will do) across the tire.

    stangPlus2Birds Yesterday, 09:41 PM Go to last post
    Killingcivics

    My four eyed wonder

    Today was a good day, bodyguy sent me these two pics.

    A friend of a friend knew the guy who sold it to the previous owner. I found him on

    Killingcivics Yesterday, 08:39 PM Go to last post
    K_Mac

    Weld question

    You could probably get close with a small diameter rod and some help.

    What size is the tire? It looks like an 8 to me

    K_Mac Yesterday, 08:34 PM Go to last post
  • Recent Article Comments

  • Follow & Like FEP!

    Instagram