Close



  • fgross2006

    There is no available content written by fgross2006
  • New Classified Posts

    STREETFIGHTER50

    79-86 Nicely Modded Hatch or Notch

    Im in Rocklin, CA, but Id travel for a car that I like. 86 would be my top choice, but depending on the mods and how clean 79-86 is fine.

    STREETFIGHTER50 01-21-2022, 05:34 PM Go to last post
    FoxChassis

    79-86 Nicely Modded Hatch or Notch

    Full location (city and state) required.

    It would also help if you indicated which year(s) you wanted, which is limited to 79-86.

    FoxChassis 01-21-2022, 03:40 PM Go to last post
    STREETFIGHTER50

    79-86 Nicely Modded Hatch or Notch

    Itchin for another clean Fox. Would like a tastefully modified street car that can handle some spirited driving up in the foothills once in a while. I

    STREETFIGHTER50 01-21-2022, 01:25 PM Go to last post
    airplanedriver

    Entex 1/20 scale mustang cobra model

    Kinda rare early 80s Entex mustang cobra 1/20 scale model. Kit is complete.only issue is box top is discolored and has random tape marks. Check out pics,

    airplanedriver 01-21-2022, 12:53 AM Go to last post
    bwguardian

    Amp pull switch

    That's what I recall from my ole 82 GT from back in the day. My girlfriend at the time had an 83 which did not have it, but hers was a late 83 with the

    bwguardian 01-17-2022, 01:42 PM Go to last post
  • Recent Forum Posts

    Killingcivics

    My four eyed wonder

    Figured I should show the cars that have donated their lives to save this particular 1985.

    The cut up green 1985 was sad to see. It was

    Killingcivics Today, 10:25 AM Go to last post
    SLow5.0

    Transmission vibrating hard at idle

    BTW: I did replace the Novi 1000 unit with a Vortech V2 s trim. Basically had the cost of the plus had to get a new front supercharger mount plate and

    SLow5.0 Today, 10:07 AM Go to last post
    SLow5.0

    Transmission vibrating hard at idle

    Still have the hangers in my car. Just in case I ran into you. For right now the engine setup, Im using a back up engine I had. The blower setup I

    SLow5.0 Today, 10:01 AM Go to last post
    SLow5.0

    Hurst shift rebuild

    When I had the stock handle on it I actually had solid bushing inserts for it but now it has a hurst chrome stick.


    Sent from my iPhone

    SLow5.0 Today, 09:45 AM Go to last post
    68P51

    LTD LX Tachometer with 1986 3.8 V6 CFI

    Thanks. I had seen that, but still not sure if it will work. There is no tach wire on my harness, and I'm not sure where to get it from. From the

    68P51 Today, 09:42 AM Go to last post
  • Recent Article Comments

  • Follow & Like FEP!

    Instagram