Close



  • New Classified Posts

    1redcat

    crimson cat 83 black magic or white

    looking to buy an 83 cat 83 black magic or any year white magic or any RS.cars must be t-top have original complete interior and car.would like original

    1redcat Yesterday, 08:03 PM Go to last post
    wraithracing

    Convertible Windows

    Title Corrected. GLWS

    wraithracing Yesterday, 05:13 PM Go to last post
    lxcoupe86

    1982 mustang gt coyote swap

    Would love to see pictures!

    lxcoupe86 Yesterday, 01:43 PM Go to last post
    dtmilsap

    Convertible Windows

    No problem, that's why we are members of this site, to figure out and learn about all the little things that make 4-eyes different .

    Sent

    dtmilsap Yesterday, 10:09 AM Go to last post
    mustangs4me

    Convertible Windows

    I will go $30 to move these as I'm tired of them being around here and I was wrong about the fitment. Scott

    Sent from my moto z4 using Tapatalk

    mustangs4me Yesterday, 10:08 AM Go to last post
    mustangs4me

    Convertible Windows

    You guys are right, I will edit the post. Sorry

    Sent from my moto z4 using Tapatalk

    mustangs4me Yesterday, 10:03 AM Go to last post
  • Recent Forum Posts

    ZephyrEFI

    2020 What did you do to your Fox today?

    I'm not a drag racer though. For me, it's all about that part throttle, low RPM responsiveness. My dailies are both EcoBoost powered and that's where

    ZephyrEFI Today, 11:34 AM Go to last post
    gr79

    Timing Belt Jumps

    Replaced mine last year with Ford M-6268-A221 square tooth timing belt E5RE-6268-A2A GATES.
    Listed in older Ford Performance Catalogs.
    Ford

    gr79 Yesterday, 11:31 PM Go to last post
    gr79

    79 2.3 turbo

    May also change to lower compression pistons next time if stock type becomes hard to get.
    Runs fine now on 87 regular. No 'peck knocking'.

    gr79 Yesterday, 10:48 PM Go to last post
    richpet

    2020 What did you do to your Fox today?

    Nothing of late. Too hot for this person to lie on the concrete in the sun.
    But.... Bell housing FINALLY arrived so plan to install drivetrain (bell/trans/shaft/starter)

    richpet Yesterday, 10:37 PM Go to last post
    richpet

    8.8 install

    Probably not the easiest, but when I jacked mine up in (also a solo job) I did it about the same way. Upper arms on body, then jacked it up and installed

    richpet Yesterday, 10:33 PM Go to last post
  • Recent Article Comments

  • Follow & Like FEP!

    Instagram